Postupoval jsem dle návodu na stránkách výrobce, kde je vše rozepsané krok po kroku. Nahrání firmwaru byla otázka 90 sekund i se zapojením jednotky do USB a restartem. Opětovné nastavování heliny šlo už rychle a do 20 minut bylo vše hotové i překontrolované... nezbývalo nic jiného než vyzkoušet.
Při zkušebním letu jsem si všiml pár drobných zlepšení a to hlavně vylepšení stability vrtulníku díky úpravě algoritmu pro ocasní vrtulku... ocas se mi zda pevnější a líp drží při výkrutách.
Zde je seznam změn co nový update přinesl:
v3.0.0
- reduced swash servo peak power consumption
- Throttle and Aux channel now directly "online" after power up in single line mode.
- New swashplate algorithm: again more direct and sudden reaction to cyclic commands
- At parameter menu point "F" (Revomix) now also preset values selectable. So computer is not absolutely necessary to use RevoMix function (only for fine tuning)
- Calculation of Revomix is now depending on the pitch adjustment at setup menu point "K". So it is possible to use assymetric pitch values in combination with asymmetric Revomix new cyclic response parameter (parameter point "G") This allows to select a more natural - "flybarlike" control feeling. Please don't use too high expo or ATV/DR values in the beginning as this could produce a very "extreme" response of the heli. Also only increase the different stages step by step.
- New pitch boost function (parameter menu point H)
- New tail algorithm. Perfect constant tail rate also in close proximity to the maximum rotation rate and faster response when changing rotation direction. Therefore it is necessary to outfly the maximum possible tail gain and only increase HH-Gain (parameter menu point D) as far as necessary. Again as mentioned before don't forget to verify that the tail stick does not control the gyro into "free-wheel" mode.
- Also as already mentioned: now DSMX and DSM2 satellites supported and selectable. Again don't forget: only the type of satellite remote receiver is important for correct choice in the Microbeast.
- Trimm function at parameter menu point A slightly modified. It now works quite similar to a transmitter's trimm function by tapping the control stick to trimm the swash in small steps.
- Now compatible to our new BEASTRX receivers which support our new SRXL singleline protocol. Receivers will be fully compatible to Futaba fasst and frSky systems. Coming soon ..
v3.0.8
- Unfortunately since V3.0.0 receivers with SRXL protocol could not be used because power output to swash and tail servos has been seriously disturbed. This could range from slight twitching to total dropouts for several hundred milliseconds. As this was depending on the chosen servo frequency and the applied servos, we didn't notice.
- Improved locking in on the elevator axis when using large / heavy helicopters.
- Uniform rotation rates on aileron and elevator when same amount of stick input is applied.
- Adapted values in parameter menu points G and H. The values are now lower in the beginning and rise progressively.
- Improved sensor signal conditioning.
Víceméně se jedná jen o menší vylepšení verze 2... pokud jste spokojeni na stávající verzi, tak za každou cenu neaktualizujte... víceméně to v 90% případů ani nezaznamenáte, že lítáte na novější verzi ;)
